Technical Tip : How to solve 'no output' issue on CLI
Description
This article describes how to solve the 'no output' issue on CLI.
Solution
1) Access the problematic via SSH.
2) Execute a cli command to see whether 'httpclid' exists or not.
Command: # diagnose sys top 5 200
Result: No 'httpclid' exists in the list.
Checkpoint: If 'httpclid' does not exist or shows 'T' state, it is not normal.
Command: fnsysctl killall httpclid
Result:
- 'httpclid' newly appears in the list.
Previously it was not in the list.
- 'httpclid' shows 'S' state and has new PID.
Previously it showed “T” state in the list.
This article describes how to solve the 'no output' issue on CLI.
Solution
1) Access the problematic via SSH.
2) Execute a cli command to see whether 'httpclid' exists or not.
Command: # diagnose sys top 5 200
Result: No 'httpclid' exists in the list.
Checkpoint: If 'httpclid' does not exist or shows 'T' state, it is not normal.
FGVM01TM2------2 (global) # diagnose sys top 5 2003) Execute a cli command to restart 'httpclid'.
Run Time: 0 days, 7 hours and 50 minutes
0U, 0N, 0S, 100I, 0WA, 0HI, 0SI, 0ST; 2012T, 681F
ipshelper 314 S < 0.0 3.9
cmdbsvr 124 S 0.0 3.3
ipsengine 315 S < 0.0 3.0
httpsd 379 S 0.0 3.0
miglogd 144 S 0.0 2.4
pyfcgid 284 S 0.0 2.3
httpsd 209 S 0.0 2.2
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
httpsd 380 S 0.0 2.0
reportd 163 S 0.0 2.0
httpsd 317 S 0.0 1.8
pyfcgid 286 S 0.0 1.8
forticron 155 S 0.0 1.7
httpsd 656 S 0.0 1.6
cw_acd 180 S 0.0 1.4
httpsd 1338 S 0.0 1.4
miglogd 196 S 0.0 1.4
Command: fnsysctl killall httpclid
Result:
- 'httpclid' newly appears in the list.
Previously it was not in the list.
- 'httpclid' shows 'S' state and has new PID.
Previously it showed “T” state in the list.
