Technical Tip: How to clear utilization of the disk partition from the WAD process on FortiGate
| Description | The article describes how to clear disk utilization from the WAD process. |
| Scope | FortiGate. |
| Solution | To check utilization of the partition, see step 4 in Technical Tip: FortiGate hard drive and SMART status.
If the WAD process is consuming too much memory ('diagnose system top-mem'), use the following debug commands to clear the partition.
diagnose debug enable
Wait for a while, and then disable the debug commands.
diagnose debug disable
Note: Clearing the partition with the command above will impact traffic.
Check the partition utilization with 'fnsysctl df -k' and confirm the partition has been reset.
Related documents: |