Technical Tip: How to check EIGRP packets in FortiGate unit

This articles describes how to check EIGRP packets passing through the FortiGate unit.

Normally, FortiGate may not support EIGRP routing. But sometimes FortiGate unit may be part of the network with EIGRP routing and one might want to troubleshoot EIGRP packets passing through the FortiGate.

EIGRP (Enhanced Interior Gateway Routing Protocol)

To filter and capture only the EIGRP packet passing through the firewall, use the following CLI commands.

Example

# diagnose sniffer packet vlan45 "proto 88" 4 0

interfaces=[vlan45]
filters=[proto 88]
pcap_lookupnet: vlan45: no IPv4 address assigned
15.417898 vlan45 -- 192.168.102.253 -> 192.168.102.254: ip-proto-88 20
15.864769 vlan45 -- 192.168.101.253 -> 224.0.0.10: ip-proto-88 40
18.047781 vlan45 -- 192.168.102.254 -> 224.0.0.10: ip-proto-88 58
18.085863 vlan45 -- 192.168.102.253 -> 224.0.0.10: ip-proto-88 50
18.433612 vlan45 -- 192.168.102.253 -> 192.168.102.254: ip-proto-88 20
19.573145 vlan45 -- 192.168.101.254 -> 224.0.0.10: ip-proto-88 46

Note: If one wants to see the file with .pcap format to open in Wireshark, change the verbose level from 4 to 6.

# diagnose sniffer packet vlan45 "proto 88" 6 0