Skip to main content
Sindre-FTNT
Staff
Staff
Oct 18, 2019 2:36 PM UTC

Technical Tip: FG-92D hardware limitation

Description
This article explains hardware limitation for FortiGate model FG-92D.
FortiOS 5.4.0 reported an issue with the FG-92D model in the Special Notices. FG-92D High Availability in Interface Mode section of the release notes.
Those issues were related to the use of port 1 through 14, include:

- PPPoE failing, HA failing to form.
- IPv6 packets being dropped.
- FortiSwitch devices failing to be discovered.
- Spanning tree loops may result depending on the network topology.

Solution
FG-92D does not support STP.
These issues have been improved in FortiOS 5.4.1, but with some side effects with the introduction of a new command, which is enabled by default:

#config global
set hw-switch-ether-filter <enable | disable>
When the command is enabled:
- ARP (0x0806), IPv4 (0x0800), and VLAN (0x8100) packets are allowed.
- BPDUs are dropped and therefore no STP loop results.
- PPPoE packets are dropped.
- IPv6 packets are dropped.
- FortiSwitch devices are not discovered.
- HA may fail to form depending the network topology.

When the command is disabled:
- All packet types are allowed, but depending on the network topology, an STP loop may result.

Thought Leadership. Security Summit. Thursday, November 12th, PGA National Resort, Palm Beach Gardens, FL.
Security Operations Summit: Modernize SecOps. Operate AI-Native.AMER: November 4 | 9:00 AM PST. India and SAARC: November 5 | 10:00 AM IST. EMEA: November 5 | 10:30 AM CET. APAC: November 5 | 11:00 AM SGT