Technical Note: How to delete an event filter in Shelf Manager
Description
Scope
Solution
This article explains how to delete an event filter that has been configured in Shelf Manager.
Scope
Shelf Manager.
Solution
A specific event_filter entry can be deleted by replacing the entry to 0.
1) To check if any event filter is configured
2) To configure an event filter.
3) To check that an event filter has been added.
4) To delete the event filter which was created earlier.
5) To verify that the event filter has been deleted.
1) To check if any event filter is configured
#clia getpefconfig event_filter
Pigeon Point Shelf Manager Command Line Interpreter
Active Event Filters:
None
2) To configure an event filter.
#clia setpefconfig event_filter 3 80 1 5 02 86 FF FF FF FF FF FF 0 0 0 0 0 0 0 0 0
3) To check that an event filter has been added.
# clia getpefconfig event_filter
Pigeon Point Shelf Manager Command Line Interpreter
Active Event Filters:
0x03: Software Configurable Filter
Action Mask: 0x01
Policy Number: 5, Severity: Information
Source Address: 0x86, Generator ID2: 0xff (ANY)
Sensor Type: ANY (0xff), Sensor # 255 (ANY)
Event Trigger: 0xff (ANY), Event Offset Mask: 0xffff
0: AND: 0x00, CMP1: 0x00, CMP2: 0x00
1: AND: 0x00, CMP1: 0x00, CMP2: 0x00
2: AND: 0x00, CMP1: 0x00, CMP2: 0x00
4) To delete the event filter which was created earlier.
# clia setpefconfig event_filter 3 00 0 0 00 00 00 00 00 00 00 00 0 0 0 0 0 0 0 0 0
5) To verify that the event filter has been deleted.
# clia getpefconfig event_filter
Pigeon Point Shelf Manager Command Line Interpreter
Active Event Filters:
None
