Technical Note: Configuration for connecting a D-Link model DWM-221
Description
Solution
This article describes the steps to configure a 3G D-Link USB modem model DWM-221.
Solution
The following configuration script should be implemented in the FortiGate device:
The parameters 'xxxx', 'uuuu', 'oooo' and 'vvvv' should known and set by the user.
If there are any connection issues then the following debug can be used on the FortiGate side:
config system 3g-modem custom
edit 1
set vendor "D-Link"
set model "DWM-221"
set vendor-id 2001
set product-id 7e19
next
end
config system modem
set status enable
set pin-init "AT+CPIN=\"xxxx\""
set auto-dial enable
set idle-timer 1
set redial 10
set wireless-port 2
set phone1 "*99#"
set username1 "uuuu"
set passwd1 "oooo"
set extra-init1 "at+cgdcont=1,\"IP\",\"vvvv\""
set altmode disable
set distance 11
end
The parameters 'xxxx', 'uuuu', 'oooo' and 'vvvv' should known and set by the user.
If there are any connection issues then the following debug can be used on the FortiGate side:
# diag debug reset
# diag debug disable
# diag debug application modemd -1
# diag debug app ppp -1
# diag debug enable