Staff

Technical Tip : FortiEDR Installer parameters commands

Forum|Forum|4 years ago
May 13, 2022
0 replies
2275 views

Description

This article describes the command line installer parameters.

Scope

Solution

Installer parameters

To set a property, add PROPERTY=value to the command line.

Name	Description / Use	Notes
PWD	registration password	The password used to register with the aggregator. Required to stop and uninstall collector
UPWD	uninstall password	Used during silent uninstall
EPWD	registration password	Encrypted registration password. Used by silent installer generator.
AGG	aggregator address	The aggregator address in format ip:port or hostname:port
AGG_BASE	aggregator address	The aggregator ip (if in quiet mode, use AGG instead)
AGG_PORT	aggregator port	The aggregator port (optional, default is 8081) (if in quiet mode, use AGG instead)
GWADDR	gateway address	The ip of the machine the core is running on. Only for core installer.
DEFGROUP	default group	The default group for collector to be registered to. Optional.
ORG	organization	The organization the collector or core belongs to
RMCONFIG	remove program data	During uninstall, if this property is set will remove the program data directory
ALT	altitude	Set the default altitude value
VDI	use vdi	Enable vdi (VDI=1) or disable (VDI=0)
CITRIXPVS	Installation on Citrix PVS	Enable PVS (CITRIXPVS=1) or disable (CITRIXPVS=0)
PROXY	use system proxy	To enable PROXY=1 to disable PROXY=0
NEEDREBOOT	disable until reboot	Set "SOFTWARE\\enSilo\\Options\\DisableUntilReboot" to 1
ENABLE_ELAM	disable ELAM support	On first install, do not install ELAM by default: ENABLE_ELAM="0"
CUSTOMCONFIGPATH	use custom bootstrap	On first install specify bootstrap file for the collector to use

FortiEDR