Technical Note: How to determine AP power supply type
Description
Scope
Solution
This article explains how to determine power supply type of an AP.
Scope
Related products: AP822, AP832.
Software version greater than 8.0.
Software version greater than 8.0.
Solution
Controller(15)# conn ap <ap-id> where ap-id is the problematic number.
The following is an example of the output from the AP, the power supply type here is shown as POE-AT:
ap-1>sys p
ap-1>exit
The following is an example of the output from the AP, the power supply type here is shown as POE-AT:
ap 3> sys p
Hardware Type : etna
Hardware Id : 1.0
Serial Number : 0x6B8B4567
Boot Number : 120
Digital Board Version: 1.0
Software Version : 8.1-3-2
Boot Version : U-Boot 2009.11-rev-0.5 (May 20 2013 - 18:54:36)
Watchdog Enabled : 1
Meru Lab Debug mode : disabled
Meru Calibration mode : disabled
Power Supply Type : POE-AT
Runtime Image : Unknown