FortiAP 231K remaining offline when managed by a FortiGate
Description
This article describes how to troubleshoot a scenario where some E Series FortiGate firewall models are unable to manage the FortiAP-231K. Some E Series FortiGate firewall models are unable to manage the FortiAP-231K.
Scope
FortiAP.
Solution
The FortiAP can discover the FortiGate as expected.
However, the FSM (Finite State Machine) state transitions repeatedly between SULKING and DTLS_SETUP.
This behavior can be observed via the FortiAP CLI using the command:
wcfg | grep fsm-state
Root Cause:
The FortiAP-231K lacks certain self-signed CA certificates, which leads to a failure during the DTLS setup phase.
Things to check via FortiAP CLI:
cw_diag -c cert Fortinet_CA1.cerIf the output of the command above results in no output, then the issue is related to the reason why the AP is unable to be managed.
It appears that the AP is unable to verify the device certificate from the FortiGate, which is most likely due to an incorrect or missing CA1 certificate.
Steps to troubleshoot:
Upload the fix image, i.e build 4708, then upgrade to any GA of v7.4 or v7.6 code (Open a case with TAC to get the fix image).
Upgrade the FortiAP-231K to GA firmware version 7.6.6/8.0.1 or above.
Related Article:
FortiGate E Series Firewalls Unable to Manage FortiAP-231K access points
