Description This article describes the command 'diagnose netlink device
list' which helps to display all the interface counters of the FortiGate
device at once in real-time. Scope To check if any rapid increase in any
drop counter or to check/verify ...
Description This article describes how to perform debugging to see if a
link monitor is occurring in FortiGate. Scope FortiGate. Description In
troubleshooting scenario to see if FortiGate is performing link monitor
and its status. Perform the follow...
Description This article describes how to check which profile of the
file filter the files matching Scope FortiGate v7. Solution Run the
following command: diagnose sys scanunit debug file-filter enable diag
debug enable<----- To start debug, // init...
Description This article describes how to configure the PPPoE interface
in FortiGate if ISP does not have an IP but just a VLAN ID. Scope
Firmware 7.0 and above and in CLI only. Solution Step 1: Create a VLAN
interface/sub-interface under the require...
Hi Team, No. But it will depend on packet flow. If your vlan interface
is ingress interface for packet then no need for policy. Otherwise
policy will be required.
seems like a new feature is added. If time difference between ntp
obtained time and manually set time is more than 2 mins, then this error
message will appear
https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiGate-time-is-out-of-sync/ta-...