Technical Tip: Configuring FortiGate HA and BGP gr...

Xav_FTNT · 11-03-2011

Purpose This article explains and provides the configuration steps for using the port extension feature available on FortiSwitch 4.0 MR3.The port extension feature allows the backplane fabric interface of a FortiSwitch 5003A or FortiSwitch 5003B to b...

Xav_FTNT · 02-08-2010

Description When configuring Wan Optimization for CIFS protocol, some additional configuration needs to be applied to a Windows 2003 server in order to fully benefit from Wan Optimization acceleration. ScopeSolution In order to fully benefit from CIF...

Xav_FTNT · 02-03-2010

Description This article describes the configuration that needs to be applied to a FortiGate HA cluster and the BGP settings so that each router (the FortiGate and its peer(s)) will keep the BGP routes in their routing table(s) to avoid traffic inter...

Xav_FTNT · 07-01-2009

Description This article describes the steps to announce multiple routes with one summary route in BGP. Scope All FortiGate or VDOM running in NAT mode. Solution Diagram: Expectations, Requirements This article contains the summary of the following c...

Xav_FTNT · 02-04-2015

My thought on this problem is that the PPPoE traffic is being handled by the CPU of Fortigate 60D and that the traffic is not offloaded to the SoC NP lite chipset. As a consequence all the traffic going through the Fortigate is going through the CPU ...

User Statistics

User Activity

Technical Note : Configuring port extension on FortiSwitch 4.0 MR3

Technical Tip: Configuring Microsoft Windows for CIFS WAN Optimization

Technical Tip: Configuring FortiGate HA and BGP graceful-restart to avoid traffic interruption during an HA failover

Technical Tip: How to implement BGP route summary (aggregation) on a FortiGate

Re: Throughput problem with FGT 60D and PPPoE connection

Technical Tip: Configuring FortiGate HA and BGP gr...

KCS

Fortinet Training Institute